FATEK SD3 Series, Instruction Manual, Page: 43 / 396

23
2. Specifications
Specifications
SD3 Series Instruction Manual
3. Amplifier
3. Amplifier
Amplifier:
Mounting holes
⌀ 5.5 (two locations)
The recommended screw: M5x12 mm and 8 mm, with spring washer
Setting panel
Used for parameter setting,
tuning, and status display
CN1 User I/O connector
Control power input, Command input,
Parallel I/O, and ABZ output
CN2 Encoder connector
Encoder connection
Mounting notch
⌀ 5.5 (one location)
The recommended screw:
M5x12 mm with spring washer
Hazardous voltage display LED
This will be lit while there is residual
hazardous voltage inside the amplifier
Motor power connector
UVW: Motor power output
Main power connection
B1 B2: Regenerative resistor connection
L1 L2 L3: Single-phase AC200 V input
FG(Protective earth) terminal
Two terminals:
M4x8 mm screw with spring washer
CN3 PC communication connector
Used for parameter settings, tuning,
and status display in the dedicated
software "Servo Studio"