FATEK SD3 Series, Instruction Manual, Page: 191 / 396

49
5
Setting Parameters
5. Setting Parameters
SD3 Series Instruction Manual
5. Parameters
5. Parameters
No. 82.0
Position command filter 2:
Selection
Settings Default Characteristics
0 to 3 0
Function
Use
Set the Position Command Filter 2.
Settings Filter Type
0 No filter
1 Reserved (Do not use)
2 Notch filter
3 γ-Notch Filter
Related To No.83.0, No.84.0, No.85.0, No.86.0
No. 82.1
Position command filter 3:
Selection
Settings Default Characteristics
0 to 3 0
Function
Use
Set Position Command Filter 3.
Settings Filter Type
0 No filter
1 Reserved (Do not use)
2 Notch filter
3 γ-Notch Filter
Related To No.357.0, No.358.0, No.359.0, No.360.0
No. 83.0
Position command filter 2:
Notch frequency
Range Default Characteristics
10 to 2,000
10
[0.1Hz]
Function
Use
Set the notch frequency for Position command filter 2.
Prerequisite Position command filter 2: Select (No.82.0) = 2 (Notch filter) or 3 (γ-Notch filter)
Related To No.82.0, No.84.0, No.85.0, No.86.0
7
Tuning
7 Tuning
7 Tuning
Common Position Control Pulse Train Command Position Control Internal Command
Velocity Control Analog Command Velocity Control Internal Command Torque Control Analog Command
Communication Operation Mode Operation Control
Alarm Detection Tuning Homing
Torque Limit Deceleration Stop and so on Vibration Control
Switch Selection Numeric Value
Control Power Cycle 2-Byte Data 4-Byte Data