FATEK SD3 Series, Instruction Manual, Page: 249 / 396

5 SD3 Series Instruction Manual
Operation
６
6. Operation
1. Configuring Operation Mode
1. Configuring Operation Mode
Using "Servo Studio"
Step1
Step2
Start
2. In the row of the parameter to edit, click on the cell in the Value
column to edit.
→ When you make a change in a value cell, *(asterisk) will appear
in the Change settings column.
3. Click Set to write to RAM.
→The *(asterisk) in the Change settings column
will disappear.
4. Click Write to save to the amplifier EEPROM.
1. Select the Parameter Tab.
6HUYR6WXGLR
Step3
Method 1, 2
Cycle control-power to finish so that the change that you
just made will take effect.
Method 2
1. Select the Communication Setttings tab.
2. Click Disconnect
6HUYR6WXGLR 6HUYR6WXGLR
Method 1
Click Disconnect under
the quick tool bar.
Double-click
on
1. Select the Communication Setup tab
(initial display)
2. List of the compatible amplifiers
→Select the amplifier that you are connecting
→ If you don't see your amplifier,
Click Get to display new versions and select your amplifier version.
3. Click
Connection Status： Offline Online
6HUYR6WXGLR
Set parameters
Finish