FATEK SD3 Series, Instruction Manual, Page: 211 / 396

69
5
Setting Parameters
5. Setting Parameters
SD3 Series Instruction Manual
5. Parameters
5. Parameters
No. 224.2
Deceleration stop:
Switch (upon control power failure)
Settings Default Characteristics
0, 1 1
Function
Use
Enable/Disable deceleration stop when an alarm of voltage drop error in the control
power supply occurs.
Settings Deceleration stop
0 Disable
1 Enable
Related To No.228.0
No. 224.3
Deceleration stop:
DBRK output after stopping
(upon Servo Off)
Settings Default Characteristics
0, 1 0
Function
Use
Select Stop State when the servo is off
Settings Description
0 Free run
1 Dynamic brake
Prerequisite No.224.0, No.232.1
No. 225.0
Emergency stop:
Warning output switch
Settings Default Characteristics
0, 1 0
Function
Use
Set whether a warning to be output or not in case of E-stop input.
Settings Warning output
0 Disable
1 Enable
No. 225.1
Emergency stop:
Warning output timing
Settings Default Characteristics
0, 1 0
Function
Use
Specify when to output warning in case of E-stop input.
Settings Warning output timing
0 After the motor makes a deceleration stop
1 Immediately after the warning occurs
Prerequisite Emergency stop: Warning output switch (No.225.0) = 1 (Output warning)
No. 225.2
Quick stop:
Smoothing filter - Switch
Settings Default Characteristics
0, 1 0
Function
Use
Enable/Disable the Velocity Command smoothing filter at the time of a quick stop.
This filter suppresses vibration caused by drastic velocity change.
Settings Velocity Command smoothing filter
0 Disable
1 Enable
Prerequisite No.229.0
-
-
-
-
-