FATEK SD3 Series, Instruction Manual, Page: 241 / 396

99
5
Setting Parameters
5. Setting Parameters
SD3 Series Instruction Manual
5. Parameters
5. Parameters
*) See the Point Table Parameter List to look up a point number and its corresponding parameter numbers.
Page 102
No. 726.0
No. 746.0
to
No. 1026.0
Internal Position:
Point table
Acceleration time (*)
Range Default Characteristics
0 to 5,000
30
[ms]
Function
Use
Set the acceleration time for the Point table.
This item indicates the amount of time for a speed command to change from 0 r/min to 1,000 r/min.
In the default setting, it takes 90 ms for the rotational speed to change from 0 r/min to 3,000 r/min.
No. 727.0
No. 747.0
to
No. 1027.0
Internal Position:
Point table
Deceleration time
(*)
Range Default Characteristics
0 to 5,000
30
[ms]
Function
Use
Set the deceleration time for the Point Table.
This item indicates the amount of time for a speed command to change from 0 r/min to 1,000 r/min.
In the default setting, it takes 90 ms for the rotational speed to change from 3,000 r/min to 0 r/min.
No. 722.0
No. 742.0
to
No. 1022.0
Internal Position:
Point table
Position (*)
Range Default Characteristics
－1,073,741,823
to
+1,073,741,823
0
[encoder pulse]
Function
Use
Set the target position in Point Table.
■ If Relative Value is selected as the Command method,
position data will determine the shift amount.
Enter a positive value for CCW rotation or a negative value for CW rotation.
■ If Absolute Value is selected as the Command method,
position data will determine the target position.
This value corresponds to ABS Position Command value (Status No.74).
Related To No.643.0
No. 724.0
No. 744.0
to
No. 1024.0
Internal Position:
Point table
Rotational speed (*)
Range Default Characteristics
0 to
Maximum Rotational Speed of Motor
0
[r/min]
Function
Use
Set the motor rotational speed for the Point Table.
Set this to a speed no higher than the max rotational speed of the motor.
-
-
-
-