FATEK SD3 Series, Instruction Manual, Page: 271 / 396

27 SD3 Series Instruction Manual
Operation
６
6. Operation
5. Position Control Mode
5. Position Control Mode
Timing Diagram and Point Table Items
Create a point table entry for each motion command. Refer to the following timing diagram for single-motion.
Example of Point Table Setting (Single-Motion)
No. Position Rotational
Speed
[r/min]
Acceleration
Time
[ms]
Deceleration
Time
[ms]
Dwell Time
[ms]
Command
Method
Running
Motion
Positioning
Complete
[pulse]
Enable/
Disable
1 5,000 300 100 150 1 Relative single (any value) enable
ON
−
Input
Select
Point No.
PCSEL1…4
Start
Motor
Rotational
Speed
Input
(Output)
MEND
PCSTART1
ON
OFF
Motion
Complete
OFF
0 r/min
ON
OFF
ON
Point No.
Point
No.1
(Output)
PM1…3
1
1
OFF
State
of Servo
Input
SVON
−
Position
Deviation
0 pulse
0
0
0
Dwell Time No.1
Positioning Complete No.1
1
10 msec (min)
10 msec (min)
17 msec (typ.)
*6
11 msec (max)
3 msec (min)
1
*5
*1, *2, *3
*4
Signal Name Description Chart
Parameter No. 644.0＝0
Parameter No. 644.0＝1
Parameter No. 644.0＝2
(Waiting for Positioning
Complete)
*1) If you want to check the motion end signal (MEND) with the User I/O output "MEND/T-LIMIT", turn T-LIMIT
output OFF, by parameter configuration and TLSEL1 OFF.
4
Connections
*2) The MEND output is OFF at Servo OFF.
*3) The PCSTART1 input is ignored when MEND output is OFF.
*4) This is enabled at the User I/O setting Option 1.
The Point No. output method depends on the [Point No. Output Method (No644.0)] setting at the time
of PCSTART1 input.
*5) Any changes made to the point table setting during a motion will not be applied to the motion.
*6) The startup timing depends on other conditions.