FATEK SD3 Series, Instruction Manual, Page: 147 / 396

5
5
A B C D E F G H I J K L M N O P Q R S
-
T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 ＋ －
- - - -
Setting Parameters
5. Setting Parameters
SD3 Series Instruction Manual
2. Setup Panel
2. Setup Panel
Display Mode Overview
Status Display Mode
Motor and amplifier statuses can be verified.
Not displayed when an alarm is occurring
Alarm Status Display Mode
You can check the present alarm in this mode.
Parameter Setting Mode
Use this mode to set up each parameter.
Quick Tuning Mode
This mode is used for tuning to automatically estimate inertia ratio change
the control gain set.
(Position Control Mode only)
Auto Tuning Mode
This mode is used to set up the parameters required for auto tuning.
Not available in Torque Control Mode.
Parameter Saving Mode
This mode enables you to save the parameters set up in Parameter Setting
Mode or Auto Tuning Mode to EEPROM.
Auxiliary Function Mode
You can perform:
- JOG Operation to execute testing with no command input from the host.
- Clear Parameter to reset all parameters to the factory default.
- Clear Encoder to initialize multi-turn data of absolute encoder.
The Setup Panel shows seven modes, each of which represents a group of functions.
Character table for 7-segement LED display
2. Using the Setup Panel