FATEK SD3 Series, Instruction Manual, Page: 274 / 396

30 SD3 Series Instruction Manual
6. Operation
5. Position Control Mode
Example of Operation 3 Continuous Speed Changes (Positioning in One Direction)
This procedure executes a series of positioning motions in order of the point numbers. Motion
instructions per point numbers are executed with no interruptions and the rotational speed
changes continuously. Positioning motions will continue up to (not including) the point number
whose Running Motion is "single".
Set Running Motion of all enabled point numbers to "continuous", and specify the first point
number for turning on CW drive signal PCSTART1.
For this motion group, set Dwell Time = 0 ms .
No. Position Rotational
Speed
[r/min]
Acceleration
Time
[ms]
Deceleration
Time
[ms]
Dwell Time
[ms]
Command
Method
Running
Motion
Positioning
Complete
[pulse]
Enable/
Disable
1 5,000 200 100 200 0 Relative
continuous
20 enable
2 3,000 300
(disable) (disable)
0 Relative
continuous
20 enable
3 2,000 100
(disable) (disable)
20 Relative Single 20 enable
For the last enabled point number, set Running Motion = "single".
If Dwell Time = 0, the acceleration/deceleration setting of the first point number that is selected upon CW start
PCSTART1 ON will be applied, and the settings of subsequent point numbers will be discarded.
Example of Point Table Setting (for motions with continuous speed changes in one direction)
ON
−
Input
PCSEL1…4
Input
(Output)
MEND
PCSTART1
ON
OFF
OFF
0 r/min
ON
OFF
ON
1
Point
No.1
Point
No.3
Command
Point
No.2
(Output)
PM1… 3
1
1
1 2 3
OFF
Input
SVON
Rotational Speed No.3
Rotational Speed No.1
Rotational Speed No.2
−
0 pulse
0
0
0
Signal Name Description Chart
State
of Servo
Select
Point No.
Start
Motor
Rotational
Speed
Position
Deviation
Motion
Complete
Point No.
Deceleration
Time No.1
Acceleration
Time No.1
Positioning Complete
No.3
Dwell Time
No.3
(Waiting for Positioning
Complete)
Parameter No. 644.0＝1
Parameter No. 644.0＝2
Parameter No. 644.0＝0