Emerson Micro Motion 2500, Configuration And Use Manual

Page: 223 / 238

Transmitter default values and ranges
(continued)
Table C-1:
Type Parameter Default Range Comments
Special units Base mass unit g
Base mass time sec
Mass flow conversion factor 1
Base volume unit L
Base volume time sec
Volume flow conversion factor 1
Variable map-
ping Primary variable Mass flow
Secondary variable Density
Tertiary variable Mass flow
Quaternary variable Volume flow
mA Output 1 Primary variable Mass flow
LRV –200.00000
g/s
URV 200.00000 g/s
AO cutoff 0.00000 g/s
AO added damping 0.00000 sec The user-entered value is correc-
ted down to the nearest lower
value in a list of preset values.
LSL –200 g/s Read-only.
LSL is calculated based on the
sensor size and characterization
parameters.
USL 200 g/s Read only.
USL is calculated based on the
sensor size and characterization
parameters.
MinSpan 0.3 g/s Read-only.
Fault action Downscale
AO fault level – downscale 2.0 mA 1.0 – 3.6 mA
AO fault level – upscale 22 mA 21.0 – 24.0 mA
Last measured value timeout 0.00 sec
mA Output 2 Secondary variable Density
LRV 0.00 g/cm3
URV 10.00 g/cm3
AO cutoff Not-A-Number
AO added damping 0.00000 sec
Default values and ranges
Configuration and Use Manual 215