EDM Solution 4+4, Installation Manual

Page: 94 / 174

Zone Information
Day Alarm Mask
LOCATION 101
1
When programming this location, you will notice that there are four options per location. You
may select one, two, three or all four of these options, however, only one number needs to be
programmed. This number is calculated by adding the option bit numbers together. Program a
seven (7) is you require options 1, 2 and 4 simultaneously (ie. 1 + 2 + 4 = 7).
Option Day Alarm Zone
1 Zone 1
2 Zone 2
4 Zone 3
8
Zone 4
Table 46: Day Alarm Zones 1 - 4
Day alarm enables a combination of zones to be monitored while the system is in the disarmed
state. Indications are available via any of the programmable outputs including the codepad
buzzer. This function has been expanded to accommodate latching and non latching day alarm
output event types.
When the system has been armed in AWAY Mode or STAY Mode, zones that have been
programmed as day alarm zones will activate the sirens and dialler just as non day alarm zones
do. When day alarm has been activated, it will ignore any zone pulse count settings that have
been programmed for that zone (ie. Zone pulse count is only relevant when the system has
been armed).
Day Alarm Resetting
An output that has been programmed for day alarm resetting will operate when a zone
programmed for day alarm has been triggered. The output will reset once the zone has
resealed. This will only occur when the system is disarmed. Refer to Output Event Type “Day
Alarm Resetting” on page 119 for more information.
Day Alarm Latching
An output that has been programmed for day alarm latching will operate when a zone
programmed for day alarm has been triggered. The
ZONE indicator and the latching output
will reset when the button has been pressed. This will only occur when the system is
disarmed. Refer to Output Event Type - “Day Alarm Latching” on page 119 for more
information.
94
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited