EDM Solution 4+4, Installation Manual

Page: 128 / 174

System Event Timers
This section covers the features that involve timing. Features such as entry and exit times,
sensor watch time, siren run time and system date and time along with a host of other timers
are discussed extensively in this section.
How To Program Entry/Exit Timers
There are two locations to be programmed for Entry Timer 1, Entry Timer 2, Exit Time For
AWAY Mode and Entry Guard Time For STAY Mode.
The first location of the timer is for programming increments of 1 second. The second location
of the timer is for programming increments of 16 seconds. By adding these two locations
together will give the total time required.
Example
If you require the entry time to expire after 18 seconds, you would need to program
“LOCATION 210” as 2 (ie. 2 x 1 second = 2 seconds) and “LOCATION 211” as 1 (ie. 1 x 16
seconds = 16 seconds). This would give you the total time of 18 seconds (ie. 2 + 16 seconds =
18 seconds).
Entry Time
The
Solution 4+4
control panel has two separate entry timers. Entry time can be
programmed between 0 and 255 seconds in increments of one second. These will prove to be
helpful in any installation that requires more than one entry timer.
Entry Timer 1
LOCATION 210 - 211
(Defaulted To 10 Seconds
)
0
Location Description
210 Increments Of 1 Second (0 – 15 Sec’s)
211
Increments Of 16 Seconds (0 – 240 Sec’s)
Table 69: Entry Timer 1 Locations
Entry Timer 1 is the delay time used by the Delay-1 zone type. Refer to “Zone Types” on page
100 for more information.
Entry Timer 2
LOCATION 212 - 213
(Defaulted To 20 Seconds)
41
Location Description
212 Increments Of 1 Second (0 - 15 Sec’s)
213 Increments Of 16 Seconds (0 –240 Sec’s)
Table 70: Entry Timer 2 Locations
Entry Timer 2 is the delay time used by the Delay-2 zone type. Refer to “Zone Types” on page
100 for more information.
128
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited