EDM Solution 4+4, Installation Manual

Page: 29 / 174

Command 999 - Display Software Version Number
This command will display the control panel's software version number. This command can
only be used with the hand held programmer.
Once access to Installer’s Programming Mode has been gained, enter command
999
followed by the
#
button to display the control panel's software version number. Two beeps
will be heard. Press the
#
button to exit this command and return to the Installer’s
Programming Mode.
Disable Factory Default
LOCATION 900
0
The system has a feature that prevents the control panel from being manually defaulted via the
default button or by using a programming key unless the Installer’s Code is known.
Any number between 0-14 programmed into this location will allow defaulting of the control
panel. If 15 has been programmed into this location, defaulting of the control panel will not
operate and the Installer Code MUST be used for further programming of the control panel.
If the Installer Code is not known, the control panel will need to be returned to your EDM
Distributor for exchange. A nominal fee applies for this service.
Electronics Design and Manufacturing Pty Limited does not recommend the use of this
feature.
If the option to prevent defaulting of the control panel is required, a special programming
procedure has been introduced to eliminate any possibility of accidentally setting this option.
The default button on the PCB must be held down while programming this location.
How To Prevent Manual Defaulting Of The Control Panel
1. Disarm the system.
2. Access Installer's Programming Mode.
3. Go to "LOCATION 900".
4. Hold down the default button.
5. Program a 15 into "LOCATION 900".
6. Release the default button.
7. Exit Installer's Programming Mode.
Programming 29
Electronics Design and Manufacturing Pty Limited ISSUE123.DOC