EDM Solution 4+4, Installation Manual

Page: 50 / 174

Walk Test Mode
Walk test mode allows you to test detection devices to ensure that they are functioning
correctly. Before activating walk test mode, isolate any zones that are not required for testing.
Refer to "Isolating Zones" on page 41 for further information.
How To Enter Walk Test Mode
1. Enter your followed by
4
and the button.
Three beeps will be heard and the STAY and AWAY indicators will begin to flash. The
codepad will beep once every second while the system is in walk test mode.
2. Unseal and seal the zones to be tested.
The codepad will sound one long beep while the horn speaker will sound one short beep
every time a zone is sealed or unsealed.
3. Press the button to exit this function.
Two beeps will be heard and the STAY and AWAY indicators will extinguish.
+
4
+
Satellite Siren Service Mode
If an EDMSAT is connected to Output 1, this function will allow you to perform service work
on the system without triggering the siren or the strobe. The unit will return to its normal
working state the next time the system is armed.
How To Enter Satellite Siren Service Mode
1. Enter your followed by
5
and the button.
Three beeps will be heard.
+
5
+
Initiate Modem Call
This function will force the control panel to dial the callback telephone number programmed in
an attempt to connect to your installer’s remote programming computer.
How To Initiate A Modem Call
1. Enter your followed by
6
and the button.
Three beeps will be heard.
+
6
+
4
5
6
50
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited