EDM Solution 4+4, Installation Manual

Page: 61 / 174

Hold Down Functions
Hold down function have been incorporated to allow easy activation of specific operations.
When a button is held down for two seconds, two beeps will be heard and a particular function
will operate. The functions available are listed below.
Arm The System In AWAY Mode
Holding the
#
button down until two beeps are heard will arm the system in AWAY Mode.
Refer to Option 2 in "LOCATION 230" on page 140 for setting this feature.
Arm The System In STAY Mode
Holding the
*
button down until two beeps are heard will arm the system in STAY Mode.
Option 2 in "LOCATION 230" on page 140 will need to be enabled for this function to
operate.
If there has not been an alarm during the armed cycle, holding the
*
button down a second
time will disarm the system from STAY Mode. Option 4 in "LOCATION 230" on page 140
will need to be enabled for this hold down function to operate.
If an alarm has occurred or entry warning has been triggered, a valid user code will need to be
used to disarm the system.
Horn Speaker Test
Holding the
1
button down until two beeps are heard will sound the horn speaker for a two
second burst. No other sounding device will sound in this mode.
If an EDMSAT (SS914) has been connected to the control panel, this function will test the
horn speaker for a two second burst followed by the strobe connected to the satellite siren.
Bell Test
Holding the
2
button down until two beeps are heard will sound the speakers for a two
second burst. No other sounding device will sound in this mode.
If an EDMSAT (SS914) has been connected to the control panel, this function will test the
horn speaker for a two second burst followed by the strobe connected to the satellite siren.
#
*
1
2
System Functions 61
Electronics Design and Manufacturing Pty Limited ISSUE123.DOC