EDM Solution 4+4, Installation Manual

Page: 116 / 174

Programmable Outputs
The
Solution 4+4
control panel has three fully programmable outputs on the main PCB
and one other programmable output that operates the codepad buzzer. These three outputs are
factory default to operate a horn speaker, strobe and an internal screamer.
Programmable outputs require four parameters to be programmed in order to operate correctly.
Event Type:
When To Operate
Polarity:
How To Operate
Time Base:
How Long To Operate For
Time Multiplier:
How Often To Operate
Event
Type
Polarity Time
Base Time
Multiplier
When To Operate
Is selected from the output event types listed on page 118.
Each digit should be entered into the two corresponding
locations for the output event type required.
How To Operate
Is selected from "Table 65: Event Type Polarities” on page
123. This determines whether the output remains operating for
the duration of the event, pulses for the duration, operates once
only (one shot) or latches on.
How Long To Operate For
Is determined by a time base and a multiplier. Refer to
"Timing Of Outputs" on page 125 for further information.
How Often To Operate For
Is determined by a time base and a multiplier. Refer to
"Timing Of Outputs" on page 125 for further information.
Output Defaults
Output 1
Location 186 - 191
Output 2
Location 192 - 197
1 14 0 0 0 0 2 0 1 0 0 0
Event
Type
Polarity Time
Base
Time
Multiplier
Event
Type
Polarity Time
Base
Time
Multiplier
Default For Horn Speaker Default For Strobe Operation
Output 3
Location 198 - 203
Codepad Buzzer
Location 204 - 209
1 15 1 0 0 0 0 12 2 1 0 1
Event
Type
Polarity Time
Base
Time
Multiplier
Event
Type
Polarity Time
Base
Time
Multiplier
Default For Screamers – RELAY Default For Entry W Day Alarm
116
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited