EDM Solution 4+4, Installation Manual

Page: 22 / 174

Installer’s Programming Commands
There are several commands that can be invoked to perform various functions once the
Installer's Programming Mode has been entered. To invoke the command, enter the
corresponding numerical code followed by the
#
button
Command Description
958
Enable/Disable Zone Status Mode When Using Hand Held Programmer
959
Test Programming Key
960
Exit Installer’s Programming Mode
961 Reset Control Panel Back To Factory Default Settings
962 Copy The Control Panel Memory To The Programming Key
963 Copy The Programming Key Data To The Control Panel
964 Erase Programming Key
965 Set Up Domestic Dialling Format
966
Enable/Disable Automatic Stepping Of Locations During Programming
999
This Command Displays The Control Panel’s Software Version Number
Only When Using The Hand Held Programmer
Table 4: Installer's Programming Commands
Command 958 - Enable/Disable Zone Status Mode
This function enables and disables the zone status display mode. When using the hand held
programmer, the zones will be displayed on the seven-segment display from left to right. If
there is a dash illuminated on the display, the corresponding zone is unsealed and if the display
is blank, the zone is sealed.
The third (or centre) display shows the number 4. The number 4 constantly illuminated
indicates that zones 1 - 4 are being displayed. The number 4 flashing indicates that tamper
zones 1 - 4 are being displayed.
Pressing the
#
button will toggle the display between the zones. This feature will prove to be
very useful during installation as it allows you to view the status of the zones directly at the
control panel, saving you time and money.
How To Enable Zone Status Mode
1. Enter Installers Programming Mode.
(ie.
1234
followed by the
#
button).
2. Enter command
958
followed by the
#
button.
Two beeps will be heard.
How To Disable Zone Status Mode
1. Enter command
958
followed by the
#
button.
Two beeps will be heard.
Example
A " - " in the display indicates the zone is triggered.
A blank display indicates the zone is normal.
--4--
A steady
4
indicates that zones 1, 2, 3 and 4 are triggered.
-À4À-
A flashing
4
indicates that tamper zones 1 and 4 are triggered.
Tamper zones report back to base as zones 9, 10, 11 and 12.
22
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited