EDM Solution 4+4, Installation Manual

Page: 99 / 174

Tamper Zones
Tamper zones are 24 hour zones only. Tamper zones are not programmable like the burglary
zones.
Tamper zones when unselaed in either the armed or disarmed state will cause an alarm. This
alarm condition will be displayed on the codepad by the relevant zone indicator flashing very
quickly (0.1 Second On / 0.1 Second Off).
If you arm the system with a tamper zone unsealed, the zone indicator of that zone will flash (2
Seconds On / 1 Second Off) to indicate that the tamper zone has been left unsealed. Burglary
zones which are left unsealed when the system has been armed will be indicated by the zone
indicator constantly illiminated.
Tamper zones will be displayed on their corrsponding zone indicator on the codepad. (Eg: If
the tamper on Zone 1 becomes unsealed, the codepad will then display Zone 1. If an alarm
occurs on a burglary zone as well as it’s parallel tamper zone during the same arming cycle,
only the burglary zone will be indicated on the codepad. Event memory recall mode will
however display that two separate alarms had occurred.
Tamper zones when reporting to the base station receiver report as Zones 9 – 12 to allow the
monitoring station to tell the difference between burglary and tamper zones. Refer to Point ID
Codes on page 71 for more information.
If a burglary zone is programmed to be silent or lockout dialler/lockout siren, the tamper zone
which is connected in parallel will also become silent or lockout dialler/lockout siren.
Zone Information 99
Electronics Design and Manufacturing Pty Limited ISSUE123.DOC