EDM Solution 4+4, Installation Manual

Page: 48 / 174

Set The Number Of Days Until The First Test Report
If test reports are required, "LOCATION 182 - 185" on page 114 will need to be programmed.
After this has been carried out, test reports need to be initiated by setting the first test report. If
the first test report is not set, the test report will be transmitted in the number of days as
programmed in the repeat interval programmed in "LOCATION 182 - 185".
Each time Installer's Programming Mode has been entered, you will need to reset the
number of days until the first test report. Otherwise, the next test report will report as
programmed in the repeat interval time.
How To Set The First Test Report
1. Enter your followed by
2
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2. Enter the to wait (1-99) until the first test report.
3. Press the button when finished.
Two beeps will be heard and the STAY and AWAY indicators will extinguish.
+
2
+
+ +
Test reports will not report if the Subscriber ID Number is 0000. The number of day’s
decrements by one at 2400 hours as set in "LOCATION 901 – 904" on page 132.
2
48
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited