Daikin VRV EMERION RXYQ-AATJA, Service Manual

Page: 93 / 429

SiUS342303E Address Setting for Wireless Remote Controller
Part 3 Remote Controller 86
4. Address Setting for Wireless Remote Controller
If setting multiple wireless remote controllers to operate in one room, perform address setting for
the receiver and the wireless remote controller.
(This includes an individual remote controller control using the group operation.)
(For the wiring for the group operation, please refer to the installation manual attached to the indoor
unit.)
The address for the receiver is set to 1 at the factory. To change the setting, set the wireless
address switch (SS2) on the signal receiver PCB according to the table below.
The address for the wireless remote controller is set to 1 at the factory. To change the setting,
proceed as follows:
1. Press FILTER SIGN RESET button and INSPECTION/TEST button at the same time for 4
seconds to enter field setting mode. ( SETTING is indicated on the display.)
2. Press FAN button and select A or b . Each time the button is pressed, the display switches
between A and b .
3. Press UP button or DOWN button to select an address from 1-3 as same as the receiver.
Address can be set from 1-6, but the receiver does not work with addresses 4-6.
4. Press RESERVE button to confirm the setting.
Setting for signal receiver PCB
Unit No. No. 1 No. 2 No. 3
Wireless address
switch (SS2)
1 2 3
1 2 3
1 2 3
Transmitter assembly
1
2 3
M
S
SS2
SS1
The side painted black indicates
the s
w itch knob position.
Setting for wireless remote controller