Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion, Configuration Manual, Page: 96 / 742

4-32
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Chapter 4 Configuring Security Contexts
Managing Security Contexts
For information about command authorization when you change between contexts, see the
“Management Access to Security Contexts” section on page 4-9 .
To change between the system execution space and a context, or between contexts, see the following
commands:
•
To change to a context, enter the following command:
hostname#
changeto context
name
The prompt changes to the following:
hostname/ name #
•
To change to the system execution space, enter the following command:
hostname/admin# changeto system
The prompt changes to the following:
hostname#
Managing Security Contexts
This section describes how to manage security contexts, and includes the following topics:
• Removing a Security Context, page 4-32
•
Changing the Admin Context, page 4-33
• Changing the Security Context URL, page 4-33
•
Reloading a Security Context, page 4-34
• Monitoring Security Contexts, page 4-35
Removing a Security Context
You can only remove a context by editing the system configuration. You cannot remove the current
admin context, unless you remove all contexts using the
clear context command.
Note
If you use failover, there is a delay between when you remove the context on the active unit or group and
when the context is removed on the standby unit or group. You might see an error message indicating
that the number of interfaces on the active and standby units are not consistent; this error is temporary
and can be ignored.
Use the following commands for removing contexts:
• To remove a single context, enter the following command in the system execution space:
hostname(config)# no context name
•
To remove all contexts (including the admin context), enter the following command in the system
execution space:
hostname(config)# clear context