
4-17
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Chapter 4 Configuring Security Contexts
Managing Memory for Rules
9 19219 19219 19219
10 19219 19219 19219
11 19219 19219 19219
backup tree 19219 19219 19219
-----------+---------+----------+-----------
Total 249847 249847
224533
Total Partition size - Configured size = Available to allocate
249847 - 224533 =
25314
If you want to distribute the rules evenly across the other 6 partitions plus the backup tree, then you can
add 3616 rules to each (with 2 left over). Remember that the backup tree must be as large as the largest
partition, so you must consider the backup tree in your calculations. For example, if you want to make
partition 6 have 24,001 rules, then you can allocate the rules like this:
Step 6
To identify the partition you want to increase in size, enter the following command in the system
execution space:
hostname(config)#
resource partition
number
Where
number
is between 0 and 11 by default. If you changed the number of partitions, the partition
numbering starts with 0. So if you have 10 partitions, the partition numbers are 0 through 9.
Step 7
To increase the partition size, enter the following command:
hostname(config-partition)#
size
number_of_rules
Where
number
is the number of rules you want to assign to the partition, in this case a higher number
than was shown in the
show resource partition
command. Use the
no
form of this command to return
to the default.
Step 8
To increase the size of other partitions, repeat Steps
6
and
7
.
Step 9
To reload the FWSM so your changes can take effect, enter the following command:
hostname(config)#
reload
If you are using failover, wait a few seconds before reloading the standby unit as well; the standby unit
does not reload automatically, and the memory partition sizes must match on both units. Traffic loss can
occur because both units are down at the same time.
Partition
Bootup Partition Size
Configured Size
Difference
6
19219
24001
4782
Backup Tree
19219
24001
4782
7
19219
22369
3150
8
19219
22369
3150
9
19219
22369
3150
10
19219
22369
3150
11
19219
22369
3150
Total: 25314
Summary of Contents for 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion
