8-29
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Chapter 8 Configuring IP Routing and DHCP Services
Configuring EIGRP
Step 2
To disable split horizon, enter the following command:
hostname(config-if)#
no split-horizon eigrp
as-number
Changing the Interface Delay Value
The interface delay value is used in EIGRP distance calculations. You can modify this value on a
per-interface basis.
To change the delay value, perform the following steps:
Step 1
Enter interface configuration mode for the interface on which you are changing the delay value used by
EIGRP by entering the following command:
hostname(config)#
interface
phy_if
Step 2
To change the delay value, enter the following command:
hostname(config-if)#
delay
value
The
value
entered is in tens of microseconds. So, to set the delay for 2000 microseconds, you would enter
a
value
of 200.
Step 3
(Optional) To view the delay value assigned to an interface, use the
show interface
command.
Monitoring EIGRP
You can use the following commands to monitor the EIGRP routing process. For examples and
descriptions of the command output, see the
Catalyst 6500 Series Switch and Cisco 7600 Series Router
Firewall Services Module Command Reference
.
•
To display the EIGRP event log, enter the following command:
hostname#
show eigrp
[
as-number
]
events
[{
start
end
} |
type
]
•
To display the interfaces participating in EIGRP routing, enter the following command:
hostname#
show eigrp
[
as-number
]
interfaces
[
if-name
] [
detail
]
•
To display the EIGRP neighbor table, enter the following command:
hostname#
show eigrp
[
as-number
]
neighbors
[
detail
|
static
] [
if-name
]
•
To display the EIGRP topology table, enter the following command:
hostname#
show eigrp
[
as-number
]
topology
[
ip-addr
[
mask
] |
active
|
all-links
|
pending
|
summary
|
zero-successors
]
•
To display EIGRP traffic statistics, enter the following command:
hostname#
show eigrp
[
as-number
]
traffic
Summary of Contents for 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion
