Canon iR3570 Series, Service Manual

Page: 80 / 722

Chapter 2
2-6
Points to Make Before Installation
Be sure to go through the following before starting the work:
1) If you are installing the machine after moving it from a cold to warm
location, be sure to leave the machine unpacked for at least 2 hours so that
the machine is fully used to the site temperature, thus avoiding image
faults caused by condensation. (The term "condensation" refers to the
formation of droplets of water on the surface of a metal object brought in
from a cold to warm place, i.e., as the result of the rapid cooling of the
moisture (vapor) around the object.)
2) The machine weighs about 80 kg. Be sure to work in a group of 4 persons
when lifting it.
Checking the Contents
F-2-11
T-2-4
Check the documentation and CD against the following table:
T-2-5
- 230V EUR model
2.2 Unpacking and Installation
2.2.1 Unpacking and Removing the Packaging Materials
0006-6724
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / iR3530 / / / / /
1) Unpack and remove the plastic bags.
- When installing a pedestal to the copier at the same time, unpack it in the
same way.
2) When installing the copier on the 2-cassette Pedestal-Y2, open the right
door [1] of the pedestal.
3) Hold the recesses [2] of the copier with 4 or more people, and place it on
the pedestal.
F-2-12
The maximum weight of the copier is approx. 80kg (including the
DADF), so be sure to lift it with 4 or more people.
Memo: When placing the copier on the cassette pedestal, be sure to align the
two positioning pins [1] to the holes on the base plate of the copier.
F-2-13
4) Close the right door of the pedestal (in the case of the 2-cassette Pedestal-
Y2).
5) Remove the packaging tapes and materials from each unit.
- Front door
- Right door
- Manual feeder unit
- Cassettes 1 and 2
- Inside the cassettes 1 and 2
- DADF (In the case of the model with a DADF)
- Platen glass
6) When installing the copier to the 2-cassette Pedestal-Y2, follow the
installation procedure for the 2-cassette Pedestal-Y2.
7) Remove the optical system fixing screw [1] at the outside of the right
[1] Drum unit 1 [7] Dial label 2
[2] Lower right cover 1 [8] Shut-down warming label 1
[3] Adjusting screw 2 [9] Toner bottle warning label 1
[4] Covering rubber 1 [10] Power cable 1
[5] Service book case 1 [11] Ferrite core 1
[6] Cassette size label 2
Operators manual: User's Guide
Operators manual CD-ROM