Canon iR3570 Series, Service Manual

Page: 614 / 722

Chapter 15
15-26
E532 8001
Stapler shift error
(Finisher-S1)
The stapler slide home
position sensor does not
go on within 11 sec
when the stapler is
shifted to home
position. Replace the finisher controller
PCB. Replace the stapler shift
motor. Check the stapler shift home
position sensor. Check the harness.
8002 The stapler slide home
position sensor does not
go off within 1.0 sec
when the stapler is
shifted from home
position.
E532 0001
Stapler shift error
(Finisher-Q3/Q4)
The home position
sensor does not go off
even after the stapler
shift motor has rotated
for a specific period of
time. Replace the finisher controller
PCB. Replace the stapler shift
motor. Check the stapler shift home
position sensor. Check the harness.
0002 The home position
sensor does not go on
even when the stapler
shift motor has rotated
for a specific period of
time.
E535 0001
Swing cam error
(Finisher-S1)
The home position
sensor does not go off
within 1000 msec after
the start of operation
when the swing arm is
shifted from home
position. Replace the finisher controller
PCB. Replace the swing cam motor.
Check the swing cam home position
sensor. Check the harness.
0002 The home position
sensor does not go off
within 1.0 sec when the
stack delivery roller
swing arm is moved
from home position.
E535 0001
Swing cam error
(Finisher-Q3/Q4)
The home position
sensor does not go off
even when the swing
motor has rotated for a
specific period of time. Replace the finisher controller
PCB. Replace the swing cam motor.
Check the swing cam home position
sensor. Check the harness.
0002 The home position
sensor does not go on
even when the swing
motor has rotated for a
specific period of time.
E537 8001
Front alignment error
(Finisher-S1)
The home position
sensor does not go on
within 2.0 sec when the
front aligning plate is
moved to home
position. Replace the finisher controller
PCB. Replace the front alignment
motor. Check the front aligning
plate drive mechanism. Check the
front alignment home position
sensor.
8002 The home position
sensor dos not go off
within 1.0 sec when the
front aligning plate is
shifted from home
position.
E537 0001
Rear alignment error
(Finisher-Q3/Q4)
The home position
sensor does not go on
within 2000 msec after
the start of operation
when the read aligning
plate is moved to home
position. Replace the finisher controller
PCB. Replace the rear alignment
motor. Check the rear aligning plate
drive mechanism. Check the rear
alignment home position sensor.
0002 The home position
sensor does not go off
within 1000 msec after
the start of operation
when the rear aligning
plate is moved form
home position.
E540 8002
Stack tray motor error
(Finisher-S1)
The operation to detect
the paper surface of the
stack tray does not end
within 1.0 sec.
Replace the finisher controller
PCB. Replace the tray ascent/
descent motor. Check the stack tray
drive mechanism. Check the paper
surface sensor.
8003
An abnormal
combination of sensor
states has been
detected.
Replace the finisher controller
PCB. Check the stack tray upper
limit sensor. Check the stack tray
lower limit sensor. Check the stack
tray upper paper surface sensor.
Check the stack tray lower paper
surface sensor.
Code Detail code Name Detection Remedy