Canon iR3570 Series, Service Manual

Page: 404 / 722

Chapter 9
9-12
F-9-48
4) Free the AC harness [1] from the edge saddle [2].
F-9-49
5) Free the relay connector [1] of the signal cable from the connector holder
[2].
F-9-50
6) Disconnect the connector [2] from the relay connector [1].
F-9-51
7) Remove the fixing film unit [1].
F-9-52
9.5.2.8 Removing the Inlet Guide
0007-7916
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Slide the inlet guide [1] in the direction of the arrow to detach.
F-9-53
9.5.2.9 Removing the Pressure Roller
0007-7918
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Remove the E-ring [1], and detach the drive gear [2].
F-9-54
2) Lift the front of the pressure roller [1].
F-9-55
3) Push in the bush [1] found at the rear in the direction of the arrow to free
it; then, detach the pressure roller.
F-9-56
Be sure to pay attention to the position and the orientation of the insulating
bush.