CAKEWALK sonar x3, Reference Manual

Page: 939 / 2094

939
Effects chains
Mixing
To add/remove an assignable knob or button
Right-click the FX Chain property page and choose one of the following commands on the pop-up
menu:
•
Add knob. Add a new assignable knob, up to a total of 6 knobs.
• Add button. Add a new assignable button, up to a total of 6 knobs.
• Remove control. Remove the assignable control.
• Learn knob/button. The FX Chain is put into a learning mode and will 'listen' to controls
touched on the plug-ins in the FX Chain. When you select Learn knob/button again, the touched
controls are assigned and displayed in the FX Chain property page. Learn mode is automatically
ended if the limit of 6 buttons or knobs is reached, or when the limit of 4 parameters for a knob or
button is reached.
To customize an assignable control
Right-click a knob or button in the FX Chain property page and choose Edit control on the pop-up
menu to open the Control Properties dialog box.
Figure 292. Assignable control properties.
A. Name B. Position C. Destination D. Start value E. End value
The Control Properties dialog box contains the following settings:
• Name. The name of the assignable control, shown as the label.
• Position. The “slot” position of the control, from left to right.
• Destination. Choose up to four automatable plug-in parameters to control with the assignable
Note: If you right-click an existing knob/button, that knob/button is reset and re-learned,
otherwise a new knob or button is created (up to a maximum of 6 buttons or knobs).
A
B
C
D
E