CAKEWALK sonar x3, Reference Manual

Page: 2011 / 2094

2011
Loop Construction view
View reference
The automatic markers appear at the note resolutions according to the Resolution setting. At the
eighth note setting, there are eight markers per measure.
This control works well for slicing audio that has more subtle changes in volume with few
dramatic transients.
The markers in a loop clip preserve the timing of the audio at that moment. Too few or too many
markers can cause unwanted “artifacts” when a loop clip is stretched.
• Threshold. The Threshold control senses transients in your audio clip and assigns a marker at
the beginning and end of each one it finds. As you increase the number in this field, smaller
transients are detected and the number of markers increases.
• Beats. The number of beats (quarter notes) in the clip.
• BPM. The tempo at which the clip was recorded.
• Pitch. The Follow Project Pitch option transposes the loop, if necessary, to the key of the
project. A loop recorded in the key of A, used in a project in the key of C, would be transposed up
three semitones if the
Follow Project Pitch check box was checked.
• Root Note. The Root Note represents the key in which the loop was recorded. The Follow
Project Pitch feature uses this information, when checked, to transpose the loop to match the
project’s key.
• Coarse Pitch. You can set the transposition of a clip, independent from the project pitch, using
the Coarse Pitch field. A positive number transposes the clip up by that number of semitones. A
negative number transposes the clip down by that number of semitones. Remember that, if the
Follow Project Pitch option is checked, the clip follows the project’s pitch, so any transposition
changes you make using this option are changes to the project pitch, not the clip pitch.
An example: The project key is C. The clip key is D. If the Follow Project Pitch option is
checked, the clip is transposed down by two semitones. A value entered into the Pitch
(semitone) field adjusts the pitch from C. If you enter “-1” the pitch would be transposed down by
one additional semitone to B.
Another example: The clip pitch is E. The desired clip pitch is D. If the
Follow Project Pitch
option is not checked, and a value of “2” is entered in the Pitch (semitones) field, the clip is
transposed down two semitones to D from the original pitch of E.
• Fine Pitch. The Pitch (fine) field allows you to make tuning adjustments or to transpose the
pitch of a clip up to 50 cents. There are 100 cents in one semitone. A Pitch (fine) setting of 1
adjusts the pitch up one hundredth of a semitone. The Pitch (fine) option can “fine tune” a slightly
out of tune clip so that it is in pitch with the remaining clips in a project.