Buffalo TeraStation 5010 TS51210RH, User Manual

Page: 151 / 211

2
In Settings, click Management .
3
Click to the right of "Configuration Management".
4
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation.
5
Select "Save current configuration to a USB drive", then click Execute .
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click
OK
. The TeraStation will
save the settings.
7
When the "finished" message is displayed, saving settings is finished. Click OK .
Troubleshooting:
If the settings are not saved to the USB drive successfully, you may receive the error message such as "The specified
operation cannot be executed.". Verify:
• The USB drive has a capacity of 1 GB or larger.
• The USB drive is not write-protected.
• Failover is configured on the TeraStation.
Applying Settings
The saved settings can be applied to a different TeraStation of the same series. If applying settings to another
TeraStation, the unit's current firmware version will be changed to the version used to save the settings.
Note: Since firmware version 2.10, saved settings cannot be applied from a USB drive which contains saved settings
from a unit running firmware version is 2.03 or earlier. In such a case, create the settings restoration USB drive again
using the unit running firmware version 2.10 or later.
1
Connect the USB drive with the saved settings to a USB port on the TeraStation.
2
In Settings, click Management .
150