Agilent Technologies Infiniium 90000 Q-Series, Programmer'S Manual

Page: 557 / 1186

Measure Commands
25
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 557
:MEASure:HOLDtime
Command
:MEASure:HOLDtime [<data_source>,<data_source_dir>, <clock_source>,<cloc
k_ source_dir>]
The :MEASure:HOLDtime command measures the hold time between the
specified clock and data sources.
<data_source> {CHANnel<N> | FUNCtion<F> | WMEMory<N> | CLOCk | MTRend |
MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<clock_source> {CHANnel<N> | FUNCtion<F> | WMEMory<N> | CLOCk | MTRend |
MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<N> CHANnel<N> is an integer, 1- 4.
WMEMory<N> is an integer, 1- 4.
<F> FUNCtion<F> is an integer, 1- 16.
<data_source
_dir>
{RISing | FALLing | BOTH}
Selects the direction of the data source edge.
N O T E
This command is only available when the E2681A Jitter Analysis Software or the
N5400A/N5401A Software is installed.