Agilent Technologies Infiniium 90000 Q-Series, Programmer'S Manual

Page: 45 / 1186

Setting Up
2
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 45
Step 2. Connect and set up the oscilloscope
The Infiniium 90000 Series oscilloscopes have three different interfaces
you can use for programming:
• USB (device port, square connector).
• LAN. To configure the LAN interface, set up the Infiniium oscilloscope
on the network as you would any other computer with the Windows XP
operating system.
• GPIB (on the 90000A Series and 90000 X- Series — the 90000Q- Series
would require the N4865A GPIB- to- LAN adapter).
When installed, these interfaces are always active.
Using the USB (Device) Interface
1 Connect a USB cable from the controller PC's USB port to the "USB
DEVICE" port on the back of the oscilloscope.
This is a USB 2.0 high- speed port.
Using the LAN Interface
1
If the controller PC is not already connected to the local area network
(LAN), do that first.
2 Contact your network administrator about adding the oscilloscope to
the network.
Setting up an Infiniium oscilloscope on a network is the same as setting
up any other computer with the Windows XP operating system.
3
Connect the oscilloscope to the local area network (LAN) by inserting
LAN cable into the "LAN" port on the oscilloscope.
Using the GPIB Interface
1
Connect a GPIB cable from the controller PC's GPIB interface to the
"GPIB" port on the oscilloscope.
2 Configure the oscilloscope's GPIB interface:
a In the Agilent Infiniium software interface, choose
Utilities > Remote
Setup... .
b
In the Remote Setup dialog, use the GPIB Address field to set the
address.