Agilent Technologies Infiniium 90000 Q-Series, Programmer'S Manual

Page: 479 / 1186

Measure Commands
25
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 479
• ":MEASure:CTCDutycycle" on page 510
• ":MEASure:CTCJitter" on page 512
• ":MEASure:CTCNwidth" on page 514
• ":MEASure:CTCPwidth" on page 516
• ":MEASure:DATarate" on page 518
• ":MEASure:HOLDtime" on page 557
• ":MEASure:JITTer:HISTogram" on page 559
• ":MEASure:JITTer:MEASurement" on page 560
• ":MEASure:JITTer:SPECtrum" on page 561
• ":MEASure:JITTer:STATistics" on page 570
• ":MEASure:JITTer:TRENd" on page 571
• ":MEASure:NCJitter" on page 578
• ":MEASure:RJDJ:ALL?" on page 618
• ":MEASure:RJDJ:APLength?" on page 620
• ":MEASure:RJDJ:BER" on page 622
• ":MEASure:RJDJ:CLOCk" on page 624
• ":MEASure:RJDJ:EDGE" on page 625
• ":MEASure:RJDJ:INTerpolate" on page 626
• ":MEASure:RJDJ:PLENgth" on page 629
• ":MEASure:RJDJ:SOURce" on page 633
• ":MEASure:RJDJ:STATe" on page 634
• ":MEASure:RJDJ:TJRJDJ?" on page 635
• ":MEASure:RJDJ:UNITs" on page 636
• ":MEASure:SETuptime" on page 639
• ":MEASure:TIEClock2" on page 656
• ":MEASure:TIEData" on page 658
• ":MEASure:UNITinterval" on page 670
FFT Commands
The :MEASure:FFT commands control the FFT measurements that are
accessible through the Measure subsystem.
Measurement
Setup
To make a measurement, the portion of the waveform required for that
measurement must be displayed on the oscilloscope.
• For a period or frequency measurement, at least one and a half
complete cycles must be displayed.
• For a pulse width measurement, the entire pulse must be displayed.