8
Reverse this procedure to install the disk drive assembly.
Check that the following assemblies are properly installed before installing the disk drive:
•
Power Supply
•
LCD Display
•
Front Panel
•
CPU Board
•
Acquisition Board
•
Oscilloscope/Pattern Generator Board (if installed)
To remove and replace the acquisition board
1
Using previous procedures, remove the following assemblies:
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive Assembly
2
Disconnect the following cables from the acquisition board:
C A U T I O N
When reconnecting the cables, the ribbon cable from the CPU Board to the Acquisition
Board must not be connected to J12. This cable goes from the CPU Board to J13 (at the edge
of the Acquisition Board). If the cable is connected to J12 on the Acquisition Board
equipment damage will occur.
Bottom of the acquisition board
•
Power Sense
•
Fan
•
Power Supply
•
CPU Board
•
Oscilloscope or Pattern Generator Board (if installed)
Top of the acquisition board
•
Trigger input (white wire to J6)
•
Trigger output (orange wire to J5)
Replacing Assemblies
To remove and replace the acquisition board
6–7
Summary of Contents for 1670G Series
