G 01069 - Edition 07 - July 12
3/4
C 43
Use of the M4 monitoring system for
pumping operation
Pumping shut-down
Press on
STOP
key and valid with
ENTER
.
The following operations will perform automatically:
inlet valve closes (if any and if selected),
pump(s) stop(s),
injection of purge gas continues during the shutdown phase (P and
H versions only) if timing has been programmed (0 to 120 min).
Red indicator light ”fault”
Yellow indicator light ”warning”
Green indicator light ”running”
Emergency stop
When the pump has been configurated for automatic restart after a power
failure, it is the responsibility of the user to take all the measures required
to prevent risks resulting from this type of operation.
When the “STOP IN PROGRESS” message appears on the display, don’t
intervene on the pump: risk of injury by contact with hot surfaces. Wait for
the “PUMPING STOPPED” message before intervening on the pump.
Auto-restart
configuration
In standart configuration (factory configuration), when there is a loss of
voltage, system is stopped. When the voltage comes back, to restart the
system, it is necessary to press
START
.
The automatic restarting is possible if
AUTO RESTART
is set on
ENABLED.
For an extended shutdown of the pump, refer to the safety
recommendations «shutdown procedure for discontinuous operation» (see
chapter C00).
adixen Vacuum Products - Operating instructions - ADP/ADS Series Two
