ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 80 / 789

Chapter 4 Web Configurator
XS3800-28 User’s Guide
80
Loopback
Interface This link takes you to a screen where you can configure the IPv4 loopback interface settings on
the Switch.
OSPF Click the link to unfold the following sub-link menu.
IPv4 OSPF This link takes you to screens where you can view the OSPF status and configure OSPF settings for
IPv4.
Policy Routing This link takes you to screens where you can configure policy routing rules.
RIP Click the link to unfold the following sub-link menu.
IPv4 RIP This link takes you to a screen where you can configure the RIP (Routing Information Protocol)
direction and version for IPv4 RIP timer, and the method of preventing routing loops.
Router Setup This link takes you to a screen where you can enable Equal-Cost MultiPath (ECMP) routing and set
the criteria the Switch uses to determine the routing path for a packet.
Static Routing Click the link to unfold the following sub-link menu.
IPv4 Static
Route
This link takes you to a screen where you can configure IPv4 static routes. A static route defines
how the Switch should forward traffic by destination IP address and subnet mask.
IPv6 Static
Route
This link takes you to a screen where you can configure IPv6 static routes. A static route defines
how the Switch should forward traffic by destination IP address and prefix length.
VRRP This link takes you to screens where you can configure redundant virtual router for your network.
SECURITY
AAA Click the link to unfold the following sub-link menu.
RADIUS
Server
Setup
This link takes you to a screen where you can configure your RADIUS (Remote Authentication Dial-
In User Service) server settings for authentication.
Server
Setup
This link takes you to a screen where you can configure your (Terminal Access Control-
ler Access Control System Plus) server settings for authentication.
AAA Setup This link takes you to a screen where you can configure authentication, authorization and
accounting services through external servers. The external servers can be either RADIUS or
(Terminal Access Controller Access Control System Plus).
Access Control Click the link to unfold the following sub-link menu.
Service
Access
Control
This link takes you to a screen where you can decide what services you may use to access the
Switch.
Remote
Managem
ent
This link takes you to a screen where you can specify a group of one or more “trusted computers”
from which an administrator may use a service to manage the Switch.
Account
Security
This link takes you to a screen where you can configure account security settings on the Switch.
ACL Click the link to unfold the following sub-link menu.
Classifier This link takes you to screens where you can configure the Switch to group packets based on the
specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform special treatment
on the grouped packets.
Anti-Arpscan This link takes you to screens where you can enable anti-arpscan on the Switch and ports, and
view the port state. You can also create trusted hosts, view blocked hosts and unblock them.
BPDU Guard This link takes you to screens where you can enable BPDU guard on the Switch and ports, and
view the port state.
Storm Control This link takes you to a screen to set up broadcast filters.
Errdisable This link takes you to a screens where you can view errdisable status and configure errdisable set-
tings in CPU protection, errdisable detect, and errdisable recovery.
Table 18 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION