ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 379 / 789

Chapter 54 Spanning Tree Protocol
XS3800-28 User’s Guide
379
Figure 282 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status (Stacking Mode)
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the Switch. This
screen is described in detail in the section (
Section 54.4 on page 382 , Section 54.6 on page 388 , and
Section 54.8 on page 394 ) that follows the configuration section for each STP mode. Use the SWITCHING
> Spanning Tree Protocol > Spanning Tree Setup screen to activate one of the STP standards on the
Switch.
54.3 Spanning Tree Setup
There are three Auto path-cost Mode s (see Table 185 on page 381 ). Choose the Auto Path-cost Mode
according to the device average link speeds in the STP network.
If most of your devices support high link speed, you should select Long or User-defined mode. The path
cost of link speed slower than 10 Mbps can be set to 2000000, and the path cost of link speed faster than
10 Gbps can be set to 200. This way, the path costs can better reflect actual link speeds with a wider
range (32 bits) of path cost values. If the link speeds within the system are averagely smaller than 1
Gbps, you should select
Short mode since Short mode have path cost values more detailed defined for
link speeds under1 Gbps.
The path cost values are described in the following tables.