ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 373 / 789

Chapter 53 sFlow
XS3800-28 User’s Guide
373
The following table describes the labels in this screen.
53.3 sFlow Collector Configuration
Click SWITHCING > sFlow > Collector to display the screen as shown. You may want to configure more
than one collector if the traffic load to be monitored is more than one collector can manage.
Note: You can configure up to four sFlow collectors in this screen.
Figure 278 SWITHCING > sFlow > Collector
Table 177 SWITCHING > sFlow
LABEL DESCRIPTION
Active Enable the switch button to enable the sFlow agent on the Switch.
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port This field displays the port number. In Stacking mode, the first number represents the slot ID and
the second is the port number. Please note that the default stacking ports (the last four ports of
your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this to allow the Switch to monitor traffic on this port and generate and send sFlow
datagram to the specified collector.
Sample-rate Enter a number (N) from 256 to 65535. The Switch captures every one out of N packets for this
port and creates sFlow datagram.
Poll-interval Specify a time interval (from 20 to 120 in seconds) the Switch waits before sending the sFlow
datagram and packet counters for this port to the collector.
Collector
Address Enter the IP address of the sFlow collector.
Note: You must have the sFlow collector already configured in the SWITCHING > sFlow
> Collector screen. The sFlow collector does not need to be in the same subnet
as the Switch, but it must be accessible from the Switch.
Note: Configure UDP port 6343 (the default) on a NAT router to allow port forwarding
if the collector is behind a NAT router. Configure a firewall rule for UDP port 6343
(the default) to allow incoming traffic if the collector is behind a firewall.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.