ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 455 / 789

Chapter 60 VLAN Stacking
XS3800-28 User’s Guide
455
60.6 Selective Q-in-Q
Selective Q-in-Q is VLAN-based. It allows the Switch to add different outer VLAN tags to the incoming
frames received on one port according to their inner VLAN tags.
Note: Selective Q-in-Q rules are only applied to single-tagged frames received on the access
ports. If the incoming frames are untagged or single-tagged but received on a tunnel
port or cannot match any selective Q-in-Q rules, the Switch applies the port-based Q-
in-Q rules to them.
Click SWITCHING > VLAN Stacking > Selective QinQ to display the screen as shown.
Figure 351 SWITCHING > VLAN Stacking > Selective QinQ
The following table describes the labels in this screen.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
SPVID SPVID is the service provider’s VLAN ID (the outer VLAN tag). Enter the service provider ID (from 1 to
4094) for frames received on this port.
Priority Select a priority level (from 0 to 7). This is the service provider’s priority level that adds to the frames
received on this port.
"0" is the lowest priority level and "7" is the highest.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 226 SWITCHING > VLAN Stacking > Port-Based QinQ (continued)
LABEL DESCRIPTION
Table 227 SWITCHING > VLAN Stacking > Selective QinQ
LABEL DESCRIPTION
Index This is the number of the selective VLAN stacking rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied. In Stacking mode, the first number represents the
slot and the second the port number.
CVID This is the customer VLAN ID in the incoming packets.
SPVID This is the service provider’s VLAN ID that adds to the packets from the subscribers.