Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 65 / 374

CTS55 Test Sequence
1094.0006.55 4.13 E-6
4.14 Test Sequence in Single Step Mode
To operate in the single step mode, the "Test Mode" key in the Autotest Main Menu must be set to
"Step". The test procedure is the same as described above. The CTS however stops the test after every
step and waits until the "Continue" key is pressed.
4.15 Viewing the results of a two band autotest sequence
The following two menus differentiate between the results displayed after the completion of an autotest
sequence and ultimately depend on whether a one or two band autotest sequence has been executed.
Autotest Results Menu Autotest Results Menu
When a two band test sequence has completed, the results for a particular band may be displayed by
pressing the „Other Band“ softkey. This provides a basic two way toggle between the results for each
band. Similarly, the tolerances or signalling results can also be toggled in the same way by first selecting
the signalling or tolerances menu and then pressing the „Other Band“ softkey.
In the event that a single band test has been performed, then the „Other Band“ softkey will not be
present.
Displaying the power ramp display and phase frequency graphs are doubled up into the „Meas“ softkey.
Pressing the „Meas“ softkey displays the „Power Ramp“ menu and the „Phase Freq“ menu can be
selected from within the „Power Ramp“ menu. The Power Ramp and Phase Freq graphs that are
displayed when their respective menus are selected, relate to measurements recorded in the last band
of the test sequence.
A hardcopy of the measurement results can be obtained by pressing the „Print Report“ key. This will
generate a pass/ fail report when the „Pass/Fail“ results menu is viewed and a values report when the
„Values“ results menu is viewed.
When a two band Autotest sequence has run to conclusion, then a two page report, that has results for
both test bands will be produced if requested. If the Autotest sequence has tested only a single band
then only a one page report containing results for that band will be printed if requested.