Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 71 / 374

CTS55 Getting Started With Quicktest
1094.0006.55 5.5 E-6
Explanations:
g
"MS Type" select keys
These keys are used to scroll through the list of mobile types. Selecting a mobile type will cause the
values allocated to the mobile for Input Att, Output Att and the signal level for the sensitivity meas-
urement (RxLev/RxQual and bit error rate) to be used during the test. However, as the coupler is set
to off, the attenuations are not taken into account.
h
Location update
The mobile is requested to make a Location Update on the control channel. By the Location Update,
the base station is informed that a specific mobile has been switched on in its area and is ready to
make and receive calls. If the mobile is already switched on and "registered" when the test is started,
it will indicate "service" and wait. In this case, the mobile is synchronised to a near-by base station.
Switch the mobile off and on again. If the mobile fails to perform a Location Update within a defined
time period, the test will be aborted and the LocUpd box is marked as not executed (see Autotest
menu).
i
PIN number
Please be careful when entering the PIN number. The card will be locked after three failed attempts.
The card will be released again upon entering the PUK number, which is either known to the user or
available from the office issuing the card. It is also advisable to read the relevant section of the oper-
ating instructions of the mobile. It is convenient to use the R&S test SIM card which always responds
to the number "0000". (A locked R&S SIM card can be unlocked by keying in the PUK number
12345678.)