Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 315 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 59 E-3
7.4.3 Burst Analysis Settings
The Configurations menu includes the Burst Analysis Settings submenu, where the menu items “RF
Analyzer 1” to “RF Analyzer 10” can be found. Select one of these commands for editing the respective
burst analysis parameter set.
This command permits to set the module test parameters in the Configure Burst Analysis dialog
window. In the first field, enter the channel of the signal to be evaluated, in the second the expected
training sequence of the midamble. With GSM, the training sequences are used for time
synchronization of the received bit sequence. Since this sync bit sequence is in the middle of the burst
it is called midamble.
In the third field, the expected power can be entered. This setting is signaled to the CTS. The dynamic
range of the graphics result display for power measurements also depends on these settings. The
trigger mode can be selected by a click on the desired option.
Power:
The signal must be a burst signal with a midamble. It is triggered on the incoming power.
Freerun:
The signal to be measured must contain a midamble to allow the CTS to synchronize.
By activating the Channel Input box, you can change between channel and frequency input. If the
frequency is entered, it it adapted to the GSM channel spacing.
Fig.: Configure Burst Analysis dialog window