Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 328 / 374

Windows

Application CTSgo CTS-K6
1079.2001.01 72 E-3
7.5.10 PP Test Set 1
Within the test sets, you can determine the tests to be performed for a traffic bearer. To do so, enter
the carrier of the traffic bearer to be used in the first input field. You can as well enter the carrier offset.
In addition, you can define the used slot in the respective field. Select the tests to be performed for the
RF measurements and the TX measurements by checking the respective boxes.
The assignment of frequencies to channel and offset values can be obtained from the table below.
Bear in mind that only integral offset values are permissible when testing a portable part.
Chan-
nel
0 1 2 3 4 5 6 7 8 9
Offset -3 1902.528 1900.800 1899.072 1897.344 1895.616 1893.888 1892.160 1890.432 1888.704 1886.976
-2 1900.800 1899.072 1897.344 1895.616 1893.888 1892.160 1890.432 1888.704 1886.976 1885.248
-1 1899.072 1897.344 1895.616 1893.888 1892.160 1890.432 1888.704 1886.976 1885.248 1883.520
0 1897.344 1895.616 1893.888 1892.160 1890.432 1888.704 1886.976 1885.248 1883.520 1881.792
1 1895.616 1893.888 1892.160 1890.432 1888.704 1886.976 1885.248 1883.520 1881.792 1880.064
2 1893.888 1892.160 1890.432 1888.704 1886.976 1885.248 1883.520 1881.792 1880.064 1878.336
3 1892.160 1890.432 1888.704 1886.976 1885.248 1883.520 1881.792 1880.064 1878.336 1876.608
The following RX measurements are available:
•
BER (Bit error rate)
•
FER (Frame error rate)
For these measurements, the RF output level of the CTS is defined in the RF Level field for RX
measurements. Besides, the number of frames to be sent is entered.
Fig.: Configure DECT PP Test Set 1 dialog