Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 287 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 31 E-3
Three markers (M1 to M3) are displayed at the points that are typical for this measurement; in addition
to the absolute level, the differences from the marker with the highest level are also displayed below.
The level scale is relative to the reference level of the tester, the reference level itself is indicated at
the top left of the window.
The window with the graphics display of the phase and power ramp within a burst or the IQ spectrum
can be increased or reduced at will.
When the program is in stop mode, CTSgo can be terminated by pressing the End button or the
operating mode of the CTSgo program changed by pressing the Return to Autotest button.
The operating status of CTS is indicated in the status bar. The icons have the following meaning:
“Red lamp“. Parameter setting is not yet terminated, generator setting and burst analysis are not
correctly performed.
„Green lamp“. Parameter setting is terminated, generator settings are valid and the burst analysis
or IQ spectrum measurement is in progress.
6.4.1 Sequence Control of Module Test
When the module test is called, the sequence control is automatically started. The configurations for
RF generator and burst analysis can be entered in parallel and are considered in the program when the
entries are confirmed. You may also influence the sequence control in the same way as described for
the sequence control in the autotest.