Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 155 / 374

CTS55 Test Report Printout
1094.0006.55 10.1 E-5
10 Enhanced Measurement and Test Report
Printout
Comment
The comment which is defined in the configuration menu.
Test station
Name and manufacturer of the mobile tester for which this test report was produced.
Date and Time
Date and time of the test.
Mobile
The designation of the mobile entered is that chosen with the "MS Type" key in either the Autotest menu
or the MS Test/Wait Sync menu. This designation can be changed or a new telephone entered by using
the Config MS Type menu (see section 9.9.5 for information on using the MS Type Menu).
Coupler Input Attenuation and Coupler Output Attenuation
Shows whether the coupler on option was set in either the Autotest menu or the MS Test/Wait Sync
menu. If the coupler on option was selected the value for Input and Output attenuation for the telephone
selected used during the test is printed under this heading.
Power class
Each mobile phone is assigned to a specific power class which defines the maximum and the minimum
power of the mobile. The power class is read from the mobile and the result entered here.
IMSI
(International Mobile Subscriber Identity). This is the number for calling the connected mobile phone. It
is read from the SIM card, and the result entered here.
IMEI
The International Mobile Equipment Identity is a hardware code or equipment identity which
characterises the hardware of the mobile. It consists of four fields. The IMEI number will be read from
the mobile and the result entered here.
Measurement results on channel XX
The following measurement results for the average output power and sensitivity were measured on
speech channel XX.
MS Output Power
The output power of the mobile is measured at three different power levels.
•
Standard Nominal power with which the telephone should be transmitting.
•
Measured Average output power of the mobile measured by the CTS.
•
Tolerance Upper and lower tolerance levels for the measured output power.
•
Evaluation If the measured value lies within the tolerance levels, an "OK" will be entered,
otherwise a "FAIL" entry is made.