Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 95 / 374

CTS55 Module Test
1094.0006.55 7.5 E-5
7.4.2 Running the Burst Analysis measurement
Burst Analysis Menu
Entering the "Burst Analysis" menu via the "Module Test" menu allows all the Burst Analysis
measurements to be made. The mobile should be put into its special test mode, in particular the
frequency of the mobile’s transmitted signal and the training sequence used will need to be specified.
When the mobile has been attached to the CTS and the CTS has been configured to use the same
parameters as the mobile’s transmitted signal the measureme nt results should appear.
While the CTS is searching for the mobile’s signal a small symbol (AR, standing for Auto Ranging) will
appear at the top of the menu. This symbol will disappear when the signal has been found and
measurements are being made.
Exp. Power
The power that you expect to be received by the CTS. This value aids the system’s search for the
signal.
Freq/RF Chan
The receive frequency can be set either as a channel number or as a frequency (in steps of 0.2 MHz).
The selection of which to use can be set up in the "Config Burst Analysis" menu. See section 7.7 for
information on the frequency ranges allowed.
Training Seq .
The training sequence expected to be received by the CTS from the mobile phone.