Rohde & Schwarz 1094.0006.50, Руководство по эксплуатации

Страница: 351 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 95 E-3
9 DECT Measurement Report
The measurement reports generated by the autotest provide a clear overview of measurement results.
This section describes the layout of measurement reports.
9.1 Header of Measurement Report
The header of the measurement report contains all static settings of the measurement, eg set input
and output attenuation, channel and slot of dummy carrier for the PP test and the selected
RFPI (Radio Fixed Part Identity) for the fixed part and the portable part test. The CTS identification is
output in another line. Its purpose is to facilitate the assignment of the measurement report to the
instrument used. The configuration used for the measurement is also indicated.
The header also contains general information such as date and time of completion of the
measurement, the operator’s name and a comment line. The top of the header shows the title
Measurement Report and next to it at the right a logo. In contrast to all other information, these two
elements are also printed on the subsequent pages. The Rohde & Schwarz logo printed at the right
can be replaced by another one. When items in the report are to be changed for further
measurements, select Report Settings in the Measurement menu.
9.2 Output of Measurement Information in the Report
The information on the individual measurements is indicated in five columns. The first column
describes the measurement and, if required, certain measurement conditions, eg the number of bursts
or frames or the CTS output power used.
Limits used for obtaining the decision Passed / Failed are indicated in the next two columns. A gray bar
is shown if there is no upper or lower limit for the measurement. For instance, setting a lower limit for a
BER measurement would not make sense. The measured value is indicated in column four. Values for
passed tests are displayed in green and a hook appears in the last column. Red values indicate that
the test failed and a red bar is displayed in column five. Tests not performed are displayed in blue in
Fig.: Report header
Fig.: Output of measurement information in the report