Polycom RealPresence 2000, Руководство администратора

Страница: 829 / 1130

Chapter 23-Ultra Secure Mode
Polycom, Inc.
23-47
Ethernet Monitoring
802.1x Status is displayed in the Hardware Monitor - LAN List .
The following 802.1X Statuses are possible:
• Authenticated
• Not Configured
• Failed
The following 802.1X Failure reasons are possible:
• Bad Configuration
• Link Status not Detected
White List Access
In compliance with UC APL requirements for enhanced security of web access to the RMX, a
White List containing the addresses of IP Networking Entities permitted to connect to the
RMX’s Management Network is implemented - Networking Entities such as Network Hosts,
Control Workstations, Gatekeepers SIP/ DNS Servers, etc .
Guidelines
• Only administrators can access and modify the White List .
• During First Time Installation and Configuration , when enabling the White List , the IP
address of the workstation used to run the RMX Web Client is automatically added to
the White List .
• The last White List entry cannot be deleted to prevent lock out. Any attempt to enable an
empty White List results in the display of an error message: WhiteList is empty please add
IP’s to the list if you want to enable WhiteList .
• Both IPv4 and IPv6 are supported.
• Web access to the RMX for http and https is through ports 80 and 443 respectively.
• The White List can hold up to 100 entries. An error message is displayed when
exceeding this limit.
• Access is blocked at the firewall for devices with IP addresses not listed in the White
List .
• The White List is saved during Backup , Restore and Upgrade processes.
• Changes to the White List are written to the Auditor Event File .
• Alterations to the White List do not require a system reset.