ONOSOKKI TS-3200A, Инструкция по эксплуатации

Страница: 43 / 171

3-15
3.4 Zero Adjustment
Stop shaft rotation of the torque detector and rotate only the upper motor in the no-load condition. Zero
adjustment refers to correction of the torque indication of the TS-3200A in this case. Zero adjustment is
not achieved only by connecting the torque signal cable.
The no-load condition is a condition in which the load side, drive side, or both sides of the shaft of the
torque detector are not connected.
Perform zero adjustment separately for each of the CW and CCW directions. Only the rotational direction
currently selected can be specified. When performing measurement only in either direction, perform zero
adjustment only for that direction. To set the other direction, change the direction referencing 3.3,
"Selecting Rotational Direction (CW/CCW)."
Note: Even if you use the CLR IN function in 4.1, "Using REMOTE Function" to perform zero
adjustment during CLR, this operation is not effective.
• Initial settings
• Zero adjustment for AUTO (automatic)
Perform zero adjustment automatically by capturing the average value for one second so that the torque
value currently displayed becomes zero.
• Zero adjustment for MANU (manual)
Zero adjustment can be performed manually. For example, a condition where torque is applied to some
extent is set as the zero value, then the amount of increase or decrease is displayed in reference to this
value. The zero value can be shifted in any desired manner.
Enter the numeric value without the decimal point (a sequence of numbers excluding the decimal point)
as shown below.
Display Input value
10.04 1004
Zero value
CW 10000
CCW 10000
3. Basic Operations