Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 954 / 1723

REAR AXLE –
Differential Case Assembly
27-50
12. Install the thrust washer as shown in the figure, and then
select a thrust washer so that the difference between
the left and right dimensions from the pressure ring rear
face to the thrust washer end face is the standard value.
Standard value: 0 – 0.05 mm
NOTE
Measure the distance while squeezing the V-shaped
groove manually.
13. If the distance is not within the standard value, replace
the thrust washers.
NOTE
Three types of replacement parts are available: 1.50 mm,
1.60 mm and 1.70 mm.
14. Apply specified gear oil to each part, and then insert
each part into differential case (B) in the order shown
in the illustration.
Gear oil:
MITSUBISHI Genuine Gear Oil part No. 8149630EX,
CASTROL HYPOY LS (GL-5, SAE 90), SHELL-LSD
(GL-5, SAE 80W-90) or equivalent
NOTE
Be particularly sure to apply oil to the contact surfaces
and sliding surfaces.
"
B
A
SCREW INSTALLATION
1. Align the mating marks (the same numeral on each case)
of differential case (A) and differential case (B).
2. Tighten the screw so that the cases are in close contact.
NOTE
If, even though the screw is tightened, the end surfaces
of case (A) and case (B) do not come into close contact,
probably the thrust washer and spring plate are not fit
correctly into the groove, so reassemble.
Thrust washer
Thrust washer
Spring plate
Friction plate
Friction disc
Pressure
ring