Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 955 / 1723

REAR AXLE –
Differential Case Assembly
27-51
"
C
A
DIFFERENTIAL PRELOAD INSPECTION FOR
LIMITED SLIP DIFFERENTIAL
1. After assembly, in order to check the frictional force of
the clutch plate, use the special tools to measure the
starting torque.
Standard value:
<When a new clutch plate is used>
39 – 74 Nm
<When the current clutch plate is reused>
25 – 74 Nm
NOTE
Measure the starting torque after rotating slightly. When
measuring the torque, do so at the beginning of movement.
2. If the starting torque is not within the standard value,
disassemble the differential case assembly and repair
or replace the parts.
3. Inspect the contact and sliding surfaces listed below, and
repair any nicks and burrs by using an oil stone.
D. The sliding surfaces of the thrust washer and the
case.
E. The spring contacting surface of the differential case
and spring plate.
F. The contact surfaces of the outer circumference of
the pressure ring and the inner circumference of the
differential case.
G. The sliding surfaces of the hole in the pressure ring
and the outer circumference of the side gear.
H. The projection on the outer circumference of the
pressure ring.
I. The spherical surface of the differential pinion gear
and the inner diameter of the pressure ring.
J. The V-shaped groove in the pressure ring, and the
V-shaped part in the pinion shaft.
K. The outer diameter of the pinion shaft and the hole
of the differential pinion gear.
L. The outer circumference groove of the side gear.
M. The inner circumference groove of the differential
case.
N. The sliding surface of the thrust block.
O. The sliding part of the thrust block.
MB990992
MB990989
M
F
D
E
D
E
D,N
O
I J
G
K
F
H
K
N
G
L
H
J