Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1557 / 1723

CHASSIS ELECTRICAL –
Headlamp
54-46
ON-VEHICLE SERVICE
54200090111
HEADLAMP AIMING
<USING A BEAMSETTING EQUIPMENT>
1. The headlamps should be aimed with the proper
beamsetting equipment, and in accordance with the
equipment manufacture’s instructions.
NOTE
If there are any regulations pertinent to the aiming of
headlamps in the area where the vehicle is to be used,
adjust so as to meet those requirements.
2. Alternately turn the adjusting screw to adjust the headlamp
aiming.
<USING A SCREEN>
1. Inflate the tyres to the specified pressures and there
should be no other load in the vehicles other than driver
or substituted weight of approximately 75 kg placed in
driver’s position.
2. Set the distance between the screen and the centre of
the headlamps as shown in the illustration.
3. Check if the beam shining onto the screen is at the
standard value.
Standard value:
(Vertical direction)
60 mm below horizontal (H)
(Horizontal direction)
Position where the 15
_
sloping section
intersects the vertical line (V)
4. Alternately turn the adjusting screw to adjust the headlamp
aiming.
Caution
Be sure to adjust the aiming adjustment screw in
the tightening direction.
107 mm
78 mm
Lamp centre
Screen
5 m
Distance of
vertical direction
Lamp centre
15
°
High intensity zone
(V)
(H)
Vertical direction
adjusting screw
Horizontal
direction
adjusting
screw